Encompass SR – Player is constantly beeping

• Press and hold the ▲ and ▼ buttons at the same time for two seconds to access the main menu.
• Press the ▼ button until is displayed. Press the ENTER button.
• Press the ▼ button until is displayed. The signal strength will be displayed in this section.

Signal strength on the Encompass SR is measured on a numbered scale; the higher the number, the stronger the signal strength. Under clear sky conditions, the signal strength is not considered good below 8.5; anything below this point will yield poor performance exhibited by static, music dropping out, and switching to rain fade back up if available on that output. A signal strength of 10 or higher should allow proper music playback (technicians should achieve signal strength above 8.5 before leaving the site). If signal strength measures 12 or above, there is likely an over-signal situation caused by an in-line amp that is too close to the player, or a very short coaxial cable between the player and the dish (less than 50 feet).